Koray GS240 flowering-switch quantum board

Overview

The GS240 is a 240W quantum board with a dedicated flowering switch: one toggle turns on additional Hyper Red 660nm and Far Red 730nm LEDs for the bloom phase, which is when plants set the yield that matters. In veg mode it runs warm-white; flip the switch and the board adds its red edge diodes for flowering-phase crops. All figures below come from the official GS240 product page.

Key Specifications

Parameter GS240
Power 240W
Flowering switch One switch adds Hyper Red 660nm + Far Red 730nm (off in veg / on in flower)
Coverage Veg 3’×4′; flowering 2’×4′ (or 3’×3′); two units cover 4’×4′
Chips Samsung LM301H + German-brand 660nm
Driver MeanWell
Dimming Free dimmer included; daisy-chain dimming for up to 10 units
Warranty 3 years

One Switch, Two Phases

Most quantum boards lock you into a single spectrum. The GS240 separates the two phases of the crop cycle: run it as a warm-white veg board at 3’×4′ coverage, then flip the flowering switch for the bloom stage. The added 660nm + 730nm photons target the flowering-phase response — denser flower sites and better final yield — across a tighter 2’×4′ (or 3’×3′) footprint where light intensity matters most. Two units cover a 4’×4′ flowering area.

The Spectrum Difference

The official F135 spectrum chart compares the two modes directly: the veg curve is warm-white dominant, while the flowering curve adds the Hyper Red 660nm and Far Red 730nm peaks. The chart is optimized for flowering-phase crops and medicinal plants — the same spectrum family, switchable without changing hardware.

GS240 veg vs flowering spectrum

Installation

Hang the board from its four corner hanging holes with cords from the tent top, light facing down. The driver sits outside the panel. Connect multiple boards with the daisy-chain dimmer — up to 10 units on one control — and flip each board’s flowering switch when your crop enters the bloom stage.

GS240 flowering-switch grow light in bloom-phase grow tent

FAQ

Q: What does the flowering switch do?
It turns on additional Hyper Red 660nm + Far Red 730nm LEDs for the bloom phase; off in veg, on in flower.

Q: What footprint does it cover?
3’×4′ in veg; 2’×4′ (or 3’×3′) in flowering mode; two units cover 4’×4′.

Q: How many units can I dim together?
Up to 10 units via daisy-chain dimming with the free dimmer.

Q: Where do these figures come from?
All values are from the official GS240 product page on koraylights.com.

Why Choose Koray

Koray (Zhongshan Koray Photoelectric Co., Ltd.) has designed and manufactured commercial LED grow lights since 2008, serving 1,000+ professional growers in 20+ countries and holding 300+ patents. Every figure in this article comes from the official Koray product page or the official technical specification — visit koraylights.com to request samples or full test reports.